SAP® Documentation

Single view

CPA57AE - DCE on line &23 not turned on or not in data mode. (C G R) ( OS/400 )

CPI1466 during Backup   Addresses (Business Address Services)  
This documentation is copyright by IBM.
SAP E-Book


Message : CPA57AE
DCE on line &23 not turned on or not in data mode. (C G R)

Message Long Text :

Cause . . . . . : The system cannot contact the X.21 DCE. The probable causes are:
-- The power to the local DCE is not turned on.
-- The local DCE is not in data mode.
Recovery . . . : Verify that the power to the X.21 DCE is turned on and the DCE is in data mode.
Then do one of the following:
-- Type C to cancel recovery and to inform any applications that are waiting for an operation that the recovery has been canceled.
-- Type G to start the automatic communications recovery again as defined by the system communications recovery limit (CMNRCYLMT) for line &23.
-- Type R to try the operation one more time.
If the problem continues, press F14 to run problem analysis.
Possible choices for replying to message . . . . . . . . . . . . . . . :
C -- Cancel.
G -- Start automatic recovery again.
R -- Try again one more time.
Technical description . . . . . . . . : The error log identifier is &22.
The error code is &40: The X.21 DCE remained in an uncontrolled not ready state until the system timed out.
For more information on time limits, see the IBM Implementation of X.21 Interface: General Information Manual, GA27-3287.

Message File : QCPFMSG
Library Message File : QSYS2924


Vendor Master (General Section)   Fill RESBD Structure from EBP Component Structure  
This documentation is copyright by IBM.

Length: 3268 Date: 20191114 Time: 022323     sap01-206 ( 69 ms )

Our Service

Looking for Support? Questions?

The

Consolut

Callback-Service

Leave us your contact details and we will call you back. Panels marked with * are mandatory.