SAP® Documentation

Single view

CPA58EB - Line &23 contact not successful on network interface &30. Potential cabling problem. (C N R) ( OS/400 )

Vendor Master (General Section)   General Data in Customer Master  
This documentation is copyright by IBM.
SAP E-Book


Message : CPA58EB
Line &23 contact not successful on network interface &30. Potential cabling problem. (C N R)

Message Long Text :

Cause . . . . . : The outgoing call for line &23 on network interface &30 cannot be completed because the local system has detected a loss of signal. The probable causes are:
-- A network or external devices problem.
-- A cabling problem.
-- The network type (NETTYPE) parameter is not set correctly in network interface &30.
Recovery . . . : Do one or more of the following:
-- Verify that the network and external devices are operational.
-- Ensure that the local system is properly cabled to the network.
-- Use the Work with Network Interface Description (WRKNWID) command to ensure that the value specified for the NETTYPE parameter is correct.
Reply to the message.
If the problem continues, press F14 to run problem analysis.
Possible choices for replying to message . . . . . . . . . . . . . . . :
R -- Try the dial operation to the remote ISDN system again using line &23.
C -- Cancel the dial attempt to the remote ISDN system. Any applications and subsystems that are waiting for an operation will be informed that the call has been canceled.
N -- Retry the dial attempt to the remote ISDN system. Depending on the values specified for the switched line list (SWTLINLST) and the switched line selection (SWTLINSLCT) parameters configured in each controller description, the system may choose a different line description to complete the call. The SWTLINSLCT parameter is only valid for X.25 configurations.
Technical description . . . . . . . . : The error log identifier is &22. The error code is &40, and has the following meaning:
44001F07 - Power source 1 (PS1) was not detected.
44001F08 - Layer 1 synchronization procedures were not successful.

Message File : QCPFMSG
Library Message File : QSYS2924


RFUMSV00 - Advance Return for Tax on Sales/Purchases   TXBHW - Original Tax Base Amount in Local Currency  
This documentation is copyright by IBM.

Length: 3304 Date: 20191113 Time: 074438     sap01-206 ( 1 ms )

Our Service

Looking for Support? Questions?

The

Consolut

Callback-Service

Leave us your contact details and we will call you back. Panels marked with * are mandatory.